11
c)
For the bottom (or only) EBP, remove the EBP cable knockout on the top of the EBP
front cover. See Figure 10 for the location of thetop EBP cable knockout.
d)
If you are installing more than one EBP, for each additional EBP remove the EBP
cable knockout on the top andbottom of the EBP front cover. See Figure 10 for the
location of the EBP cableknockouts.
CAUTION
A small amount of arcing may occur when connecting an EBP to the UPS. This is
normal andwill not harm personnel. Insert the EBP cable into the UPS battery
connector quickly andfirmly.
e)
Plug the EBP cable(s) into the battery connector(s) as shown inFigure 10. Up to four
EBPS may be connected to the UPS.Connect black to black,. Press the connector
tightly together to ensure a properconnection.
To connect a second EBP, unclip the EBP connector onthe first EBP and pull gently to
extend the wiring to the EBPconnector on the second EBP. Repeat for any additional
EBPs.
f)
Verify that the EBP connections are tight and the adequate bendradius and strain
relief exist for each cable.
Figure10Typical EBP Installation
g)
Replace the EBP front cover.
To replace the cover, verify that the EBP cables are routed throughthe EBP cover
knockouts, cover connects with the cover hook near the left side of theEBP cabinet.
Repeat for each additional EBP.