21
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
For 200/208/220/230/240VAC models: The power cord is supplied in the UPS
package.
Step 2: UPS output connection
For socket-type outputs, simply connect devices to the outlets.
For terminal-type input or outputs, please follow below steps for the wiring
configuration:
a)
Remove the small cover of the terminal block
b)
Suggest using AWG14 or 2.1mm
2
power cords for 3KVA
(200/208/220/230/240VAC models).
c)
Upon completion of the wiring configuration, please check whether the wires
are securely affixed.
d)
Put the small cover back to the rear panel.
Step 3: Communication connection
Communication port:
To allow for unattended UPS shutdown/start-up and status monitoring, connect
the communication cable one end to the USB/RS-232 port and the other to the
communication port of your PC. With the monitoring software installed, you can
schedule UPS shutdown/start-up and monitor UPS status through PC.
The UPS is equipped with intelligent slot perfect for either SNMP or Relay card.
When installing either SNMP or Relay card in the UPS, it will provide advanced
communication and monitoring options.
NOTE: USB port and RS-232 port can't work at the same time.
Step 4: Turn on the UPS
Press the ON button on the front panel for two seconds to power on the UPS.
Note
: The battery charges fully during the first five hours of normal operation. Do
not expect full battery run capability during this initial charge period.
