FOLDING LADDER
Caterpillar D11R Dozer
Section 1
Installation and Mounting Instructions
See Drawing 21-985
(Page 4)
Pg3
PSA-D11R-F/L
210610
PROCEDURE
1
Remove grille plates from the rear of both mudguards.
Remove the light and/or horn from the rear of the left-side mudguard.
Draw out wiring for future re-use.
2
Weld the Mounting Pads to the rear of the mudguards, in the corners made by the
mudguard top plate and vertical inner plate, and in the corner made by the rolled
outer edge of the mudguard top plate. All the rear mounting pads fit hard against
the folded rear mudguard infill. All these mounting pads have bevelled edges to
clear existing welds in the corners.
3
Measure forward from the back surfaces of the rear mounting pads and down from
the top surface of the mudguard decks to locate the side mounting pads. Weld
these mounting pads in position.
NOTE
Follow all on-site/Mine lifting and safety procedures when installing
Power Step Landings to Dozer.
Summary of Contents for PSA-D11R-FL
Page 13: ...FOLDING LADDER Caterpillar D11R Dozer Section 5 Assembly Complete Pg13 PSA D11R F L 210610 ...
Page 14: ...FOLDING LADDER Caterpillar D11R Dozer Section 5 1 Ladder Assembly Pg14 PSA D11R F L 210610 ...
Page 19: ...FOLDING LADDER Caterpillar D11R Dozer Section 5 4 Spreader Assembly Pg19 PSA D11R F L 210610 ...