Pg3
FOLDING RETRACTABLE STAIRWAY
To suit Hitachi EX3600 Excavator
EX3600-FRS 3-8-15
Section 1
Installation Notes
Remove ladder landing/ww (walkway) panel in front, exposing what I
call the fascia beam. (In front as in, towards the front of the machine).
Per 21 569
- cut through the front and back of the fascia beam.
- fit the big plate into the now-open beam.
- fit the cleat mountings to the face of the fascia beam.
- box in the space between the front and back plates of the fascia.
beam.
Modify the removed landing/ww per 21 565 and put it back where it came off.
Template 21 578.
Bolt the main mtg plate to the plate inside the beam per 21 562. DON'T RISK
ARM/HAND BY REACHING IN TO LOCATE NUTS - USE 21 573 to reach in, at least
for the first two.
Fit struts per 21 568 and then our landing to the big plate and also skirt
21 566 behind/beneath our landing (to pretty up the external view). Also the
separate floor piece that goes into the space where the ladder module floor
was - leveling if necessary.
NOTE
Follow all on-site/Mine lifting and safety procedures when installing
PSFS to Truck.
