Istruzioni per l’uso e manutenzione
Cod. OQ7.5ARG114 – GB
Emiss. 19-01-11 Rev. 0 - Agg. /
51
POWER SYSTEM SRL
Via dell’Emigrante, 11/13 - 36040 Brendola (VI) Italia
27
ELECTRIC DIAGRAM
The wiring diagram for the power is enclosed in the machine documentation
27.1 REMOTE
CONTROL
Normally all the compressors are set “only with local control”. If you also want to have remote control you must connect a switch
with an ON/OFF contact on the terminals CD-CD (max. distance 10 to 20 metres) and make the selection START MACHINE /
REMOTE in the user programming menu.
27.2 ROTATION DIRECTION CONTROL
The system that controls the motor rotation direction is managed by the phase control relay “RO”. See diagram and/or contact
Power System..
27.3 AUTOMATIC
RESTART
Normally all the compressors are set “without automatic restart”. To allow automatic restart, make the selection START MACHINE
/AUTOMATIC RESTART in the user programming menu. In the event of a blackout, when power returns the compressor restarts
automatically.
27.4 MALFUNCTION OF THE PRESSURE TRANSDUCER
In the event of a breakdown of the pressure transducer it is possible to make the compressor operate by connecting an ordinary
pressure switch with an exchange contact to the terminals (PR-PR), using the same air supply network and making the selection
PRESSURE SENSOR / PRESSURE SWITCH in the service programming menu (password required). Contact Power System..
28
GENERAL WARNINGS
28.1 ORDERING
PROCEDURE
THE ORIGINAL SPARE PARTS MUST BE REQUESTED EXCLUSIVELY FROM THE
MANUFACTURER, COMMUNICATING THE SERIAL NUMBER AND THE YEAR OF MANUFACTURE
OF THE COMPRESSOR (SEE 2.1).
THE ORIGINAL FILTERS MUST BE REQUESTED EXCLUSIVELY FROM THE MANUFACTURER,
COMMUNICATING THE CODE NUMBER FOR THE COMPRESSOR MODEL PURCHASED.
IT IS ABSOLUTELY FORBIDDEN TO REPLACE ANY COMPONENT OF THE COMPRESSOR WITH
NON ORIGINAL SPARE PARTS.
28.2 DEMOLITION
When demolishing the compressor, abide scrupulously by the regulations in force in the country concerned regarding the protection of
the environment.
ALL THE COMPRESSOR COMPONENTS MUST OBLIGATORILY BE IDENTIFIED ACCORDING TO
THE DEFINITIONS OF THE “EWC CODES” (EUROPEAN WASTE CATALOGUE) AND DISPOSED OF,
APPOINTING AUTHORISED AND SPECIALISED FIRMS, ABSOLUTELY RESPECTING THE
REGULATIONS IN FORCE IN THE COUNTRY OF DEMOLITION.
CORRECT DISPOSAL OF THE PRODUCT: THIS MARK ON THE PRODUCT OR ON THE
DOCUMENTATION INDICATES THAT THE PRODUCT MUST NOT BE DISPOSED OF WITH OTHER
DOMESTIC WASTE AT THE END OF ITS WORKING LIFE. TO AVOID DAMAGE TO THE
ENVIRONMENT OR TO HEALTH CAUSED BY THE INCORRECT DISPOSAL OF WASTE, THE USER
IS INVITED TO SEPARATE THIS PRODUCT FROM OTHER TYPES OF WASTE AND TO RECYCLE IT
RESPONSIBLY SO AS TO FAVOUR THE SUSTAINABLE REUSE OF MATERIAL RESOURCES.
DOMESTIC USERS ARE INVITED TO CONTACT THE DEALER FROM WHICH THEY BOUGHT THE
PRODUCT OR THE LOCAL OFFICE IN CHARGE OF PROVIDING INFORMATION ON SEPARATE
WASTE COLLECTION AND ON RECYCLING FOR THIS TYPE OF PRODUCT.
COMPANY USERS ARE INVITED TO CONTACT THEIR SUPPLIER AND TO CHECK THE TERMS
AND CONDITIONS OF THEIR PURCHASE CONTRACT. THIS PRODUCT MUST NOT BE DISPOSED
OF WITH OTHER COMMERCIAL WASTE.
