11
C3493pr-0922
ASSEMBLY
7
8
• Fit a
3
/
8
" -16 hex nut onto the end of the rear wheel assembly.
• Tighten the hex nuts on
both sides
of the rear wheel assembly
with the wrench.
Hint:
An extra wrench has been provided to hold the hex nut
on one side of the rear axle while tightening the hex nut on
the other side.
3
/
8
" -16 Hex Nut
Wrench
Rear Wheel Assembly
• Fit and snap a hubcap cover to each hubcap.
Hubcap Cover
Hubcap Cover
9
• Slide a
7
/
16
" washer onto a front axle.
• Slide a bushing,
ring side first
, onto a front axle.
7
/
16
" Washer
Front Axle
Bushing
(Ring Side First)
• Turn the vehicle so that the front end is toward you.
• Fit the steering linkage assembly to the front end of the vehicle.
• Insert two #12 x 1
1
/
4
" screws into the holes in the steering
linkage assembly. Tighten the screws.
• Pull the steering linkage to be sure it is secure. If it is not secure,
tighten the screws a few more turns.
Steering Linkage
Assembly
Ring Side
First
10