Sport Bar
KC
TM
Light Rack -
Front Half
• Position the sport bar with the ends on a flat surface,
as shown.
• Fit and hold the front and back halves of the KC
TM
light
rack against the sport bar. Make sure the two KC
TM
light
rack halves are aligned, and that the screw holes in the
KC
TM
light rack are aligned with the screw holes in the
sport bar.
• Snap the tabs on the front half of the KC
TM
light rack into
the slots below the light housings on the rear half of the
KC
TM
light rack.
• Insert two #6 x1
1
/
2
" screws through the holes in the back
of the KC
TM
light rack, through the sport bar, and into the
front half of the KC
TM
light rack.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
KC
TM
Light Rack - Back Half
Tabs
22
Assembly
• Align the four tabs on the inside of a light cover
with the four slots in one of the light housings on the
KC
TM
light rack. (Make sure the light covers are
positioned with the wide spaced tabs at the top.)
• Push firmly on the light cover to snap it to the housing.
• Repeat this procedure on the other side of the
KC
TM
light rack to assemble the other light.
Light Covers
Housing
Slots
23
20
• Using safety scissors, remove the sport bar brackets
from the plastic connector. Dispose of the plastic
connector.
• Position the sport bar upright.
• Position a sport bar bracket above one of the sport bar
side legs, as shown.
• Insert the tab on the inside of a sport bar bracket into the
hole in the sport bar side leg.
• Fit the ring on a sport bar support against the end of the
sport bar bracket.
• Fold the sport bar bracket over the sport bar to close it
around the sport bar and sport bar support.
Sport Bar
Sport Bar Bracket
Sport Bar Support
Tab
Hole
Side Leg
Ring
21
• Insert a #6 x 1
1
/
2
" screw into the sport bar bracket
as shown.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 20 and 21 to attach the other sport bar
support to the other sport bar side leg.
Sport Bar Bracket
Sport Bar
Sport Bar Support
15
