Power Wheels Kawasaki KFX P9723, Owner'S Manual & Assembly Instructions

20

P9723b-0920

IMPORTANT!

 If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience 

a problem, please contact Power Wheels

®

 Consumer Relations, toll-free at 

1-800-348-0751

. Or, contact your local Power Wheels

®

authorized service center. For the location nearest you, please visit us on-line at 

www.powerwheels.com

, or call 

1-800-348-0751

.

PROBLEMS AND SOLUTIONS

PROBLEM

POSSIBLE CAUSE

SOLUTION

Vehicle does not run

Undercharged battery

Charge the battery. A new battery should have been charged for at 
least 18 hours before using the vehicle for the fi rst time. After fi rst-
time use, recharge the battery for at least 14 hours after each use. 
Never charge the battery longer than 30 hours. 

Check all connectors. Make sure the charger connector is plugged 
into the battery, and that the charger is plugged into the wall.

Make sure power fl ow to the wall outlet is “ON”. 

Charger is not working

There is no sure way to tell if your charger is working unless you 
have a volt meter. If you suspect there is a problem with your 
charger, contact your local Power Wheels

®

 authorized service 

center. They can test your charger for you.

Tripped thermal fuse

The built-in thermal fuse may “trip” and shut down operation of the 
vehicle if the vehicle is overloaded or the driving conditions too 
severe. Once a fuse has “tripped”, remove your foot from the pedal 
and wait approximately 25 seconds before operating the vehicle 
again. To avoid repeated automatic shutdowns, do not overload 
the vehicle by exceeding the 65 lbs (29.5 kg) maximum weight 
capacity or by towing anything behind the vehicle. Do not drive up 
hills or run into fi xed objects, which can cause the wheels to stop 
spinning while power is still being supplied to the motors. 
If a thermal fuse continually trips, contact your local 
Power Wheels

®

 authorized service center.

Loose wire or loose connectors

Check all wires and connectors. Make sure the motor harness 
connector is plugged into the battery, and that there are no loose 
wires around the motors.

Dead battery

If your battery is old or if you have not followed Battery Care 
instructions, your battery may be dead. If you are unsure whether 
or not the battery is dead, you can have it tested at your local 
Power Wheels

®

 authorized service center.

Electrical switch damage

The electrical switches can become corroded due to exposure to 
water or moisture, or can jam due to loose dirt, sand or gravel. 
Contact your local Power Wheels

®

 authorized service center for 

diagnosis and repair. 

Motor damage

Contact your local Power Wheels

®

 authorized service center for 

diagnosis and repair.

Vehicle was running but 
suddenly stopped

Loose wire or loose connectors

Check all wires and connectors. Make sure the motor harness 
connector is plugged into the battery, and that there are no loose 
wires around the motors.

Tripped thermal fuse

The built-in thermal fuse may "trip" and shut down operation of the 
vehicle if the vehicle is overloaded or the driving conditions too 
severe. Once a fuse has “tripped”, remove your foot from the pedal 
and wait approximately 25 seconds before operating the vehicle 
again. To avoid repeated automatic shutdowns, do not overload 
the vehicle by exceeding the 65 lbs (29.5 kg) maximum weight 
capacity or by towing anything behind the vehicle. Do not drive 
up hills or run into fi xed objects, which can cause the wheels to 
stop spinning while power is still being supplied to the motors. If 
a thermal fuse continually trips, contact your local Power Wheels

®

authorized service center.