Note: Remove any paint
below ring connector
Star Washer
Ring Connector
Ground Wire
Fig.3
POWER WIRING AND SIGNAL CONNECTIONS
POWER CONNECTION
Power Plug In
A 6-pin Molex style wiring harness has been supplied to wire up the Power,
Ground and Remote Turn-on as follows:
+12V
Connect the two twisted Red wires to 12 Volt positive. To lengthen the wire harness splice
at least 12 gauge wire (10 gauge for runs longer than 10 feet) directly to the battery. Route the
wire through a rubber grommet in the vehicles firewall. If there is no factory grommet available,
you will need to install one.
IMPORTANT—You MUST install a fuse holder with a 20A fuse in line with the power cable no
further than 18-inches from the battery.
REM
Connect the single blue wire to the radio power antenna lead or remote output. This wire is
responsible for turning the amplifier on and off. If the source unit (radio) is not equipped with a
Remote lead you can connect this wire to an accessory or ignition point at the vehicle fuse block.
In this type of installation, the amplifier will be on whenever the ignition is on. To lengthen this wire
use at least 18 gauge wire and run it with exactly the same care and attention as the +12V power
cable.
GND
Connect the two twisted Black wires directly to the chassis of the vehicle. The length of
these wires should be kept to an absolute minimum and should be terminated to bare metal using
a ring terminal (see Fig 3). Should you need to lengthen the wire harness use the same gauge wire
as was run for the positive 12 Volt connections as noted above.
NOTE:
When lengthening any of the wire leads on the Power Plug-in it is recommended the wires
be soldered and taped for optimum connection and to ensure against electrical shorts.
Bolt
