TECHNICAL FEATURES
•
Class D Mono Amplifier
•
International Rectifier® Chip Set
•
Conformal Coated PC Board to Resist Moisture, Dust and Extreme Heat
•
AUX Input Accepts MP3, iPod® or Portable Source Device
•
Wrap-around Aluminum Heatsink Shell
•
Ultra Low Current Draw
•
High Damping Control Circuit
•
High Efficiency SMD Circuit Technology
•
Double Sided Copper Plated PCB
•
Digital Sound Optimization Circuitry
•
Quiet Switching
•
High Current Voltage Ripple Rejection Circuitry
•
Virtual Silence Turn On/Off Mute Circuit
•
Subsonic Filter (variable 10Hz-50Hz)
•
Wired Remote Level Control
•
Bass EQ
•
Variable LPF
•
Low Level RCA and High Level Speaker Inputs
*iPod® is a registered trademark of Apple
INSTALLATION EXPERIENCE
Installation of PowerBass mobile amplifiers requires detailed knowledge of electronics wiring and proper speaker imped-
ance. We strongly recommend installation by an authorized PowerBass dealer. This Owners Manual only provides general
installation and operation instructions. If you have any reservations about your installation skills, please contact your local
PowerBass dealer for assistance.
IMPORTANT : This amplifier is designed for operation in vehicles with 12-volt Negative ground electrical sys-
tems only.
PREPARING FOR INSTALLATION
NOTE: The tools listed below may be required for basic installation
•
An electric drill with bits
•
Philips head and standard screwdrivers
•
Wire strippers
•
Crimping tool
•
VOM (electronic volt ohm meter)
•
Heat shrink tubing and heat gun
•
Soldering iron
•
Electronic (Rosen not Acid Core) Solder
3
IR® is a registered trademark of International Rectifier Corporation.
