PowerBass XL-POD65, Application Manual

UNPACKING THE ENCLOSURE

Every attempt has been made to transport your new PowerBass Marine Pod system safely. Carefully unpack the 
enclosure and inspect it thoroughly for any damage that may have occurred during shipping. Notify your local 
PowerBass dealer immediately should you notice any damage prior to installing the unit.  Be sure to keep the 
carton and packing material until your system is operational. The original boxes will do the best job of protecting 
your speaker system if they need to be transported.

INSTALLATION EXPERIENCE

Installation of PowerBass Xtreme Marine Speakers requires experience with a variety of mechanical and electrical 
procedures. This manual only provides general installation and operating instructions. If you have any reservations 
about your installation skills or lack the proper tools, please contact your local PowerBass Xtreme dealer 
for assistance.

WAKE POD PLACEMENT TIPS 

AND WIRING RECOMMENDATIONS

When running the speaker wire through the tower bar make sure there is a clear run so the wire can enter and 
exit the tubing (some towers have obstructions in the tube). If you are not sure, check with the manufacturer of 
the tower bar.

RUBBER INSERTS

The forged Alumunium clamp is designed to fit tower bars up to 2.5” diameter. Two black rubber inserts are 
provided to assist securing the Pod mounting bracket to the various diameter tower bars.Use double sided 
automotive grade tape under the rubber inserts on the tower bar to prevent moving if necessary.

Rubber Insert for 2.0” (50.8mm) diameter tubing
Rubber Insert for 2.25” (57.15mm) diameter tubing

5

Fig.1
Rubber insert with 
speaker wire hole