7
ASSEMBLY
2600 PSI Pressure Washer
PowerBOSS™
ASSEMBLY
IMPORTANT: Read entire operator’s manual before you
attempt to assemble or operate your new pressure washer.
Unpack the Pressure Washer
1.
Remove everything from carton except pressure
washer.
2.
Open carton completely by cutting each corner from
top to bottom.
3.
Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main Unit
• Handle
• Plastic Accessory Tray
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Oil Bottle
• Parts Bag (which includes the following):
•
Operator’s Manual
•
Engine Operator’s Manual
•
Emissions Control Warranty Sheet
•
Owner’s Registration Card
•
Safety Goggles
•
Bag containing 4 multi–colored Quick Connect Spray
Tips
•
Handle Fastening Hardware Kit (which includes):
•
Carriage Bolt (2)
•
Plastic Knobs (2)
•
Tree Clips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1.
Fill out and send in registration card.
2.
Attach handle to main unit, then attach accessory tray
to handle.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect high pressure hose to spray gun and pump.
6.
Connect water supply to pump.
7.
Attach nozzle extension to spray gun.
8.
Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Accessory Tray
1.
Place handle onto handle supports connected to main
unit. Make sure holes in handle align with holes on
handle supports (Figure 1).
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts through holes from outside of the
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
3.
Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit flat against the accessory tray (Figure 3).
Align Holes
Handle
Handle
Supports
Figure 1 — Attach Handle to Base
Figure 3 — Attach Accessory Tray to Handle
Figure 2 — Secure Handle
www.mymowerparts.com
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
