PowerBoss, Inc. Copyright 2010
Admiral 38C Scrubber PB# 4100055UM Rev.* 08/10
Page 20
Starting Up
2.3.3
Adjusting the driver’s seat
The driver’s seat (Fig. 10) must be adjust-
ed so that the driver is seated comfortably
and can reach all the operating elements
with ease.
The vehicle is equipped with a
seat contact switch. The vehicle
can only be operated when the
operating person is seated on the
seat.
The Admiral 38C is equipped with a
driver’s seat which can be adjusted in a
longitudinal direction (forward and back):
1. Force the lever on the right of the seat
outwards slightly.
2. Slide the seat forward or back in steps
of 0.6 in.
Fig 10
2.4
Before starting up daily
Carry out the following checks before start-
ing the vehicle up for its daily operation
(also refer to Section 5.3.2):
1. Check the recovery tank, empty as
necessary. Clean it as necessary. Re-
fer to Sections 5.6.1 and 5.6.2.
2. Check the waste container; empty and
clean it, if necessary; refer to Section
5.7.1.
3. Fill the solution tank and cleaning
agent in accordance with the manu-
facturer’s mixing directives. Refer to
Section 3.1.4 and Section 5.5.1.
Only use cleaning agents (non-
foaming) suitable for the vehicle’s
vendor. We recommend using our
clean and care products which
are specially balanced for the
vehicles. These products meet
the requirements stipulated in
the washing and cleaning agent
directive (WRMG - Wasch- und
Reinigungsmittelgesetzes).
4. Check the battery charge and recharge
as necessary; refer to Section 5.4.1.
Before starting the vehicle for its
first working operation, carry out
an initial battery charging routine;
refer to Section 2.2.
5. Check the area where the vehicle was
parked for signs of leaks. Hoses, lines
and tanks must show no signs of leaks
or damage. If necessary,
clear up any
defects before putting the vehicle
into operation.
