Page 7
PowerBoss
®
the new owner/operator and have
•
the transfer certifi ed!
•
• The warning and instruction
plates
•
attached to the machine contain
valuable
•
advice about safe operation.
•
Immediately replace incomplete or
illegible labels.
•
For safety standards spare parts
must be equal to genuine parts!
1.3 Provisions for Operation
•
Before the fi rst operation of the
machine, fully charge the battery
with an initial charging procedure
and comply with the operating
instructions of the charger as
well as with those of the battery
manufacturer. PowerBoss cannot
be held liable for damages
resulting from the fact that
the initial charging has not or
insuffi ciently done.
•
Before operation, check
the machine for operational
safety!
Immediately remedy
malfunctions!
•
It is necessary for the operator to get
acquainted with all attachments and
controls as well as with their function
before operation begins.
•
When operating the machine use
of fi rm and skid proof shoes is
recommended.
•
The machine may be used only on
such surfaces clearly specifi ed by the
owner or his authorized representative.
•
When operating the machine take
notice of persons within the operation
area especially children.
•
Start moving immediately after brush
head has lowered otherwise the brush
might leave traces on the surface.
Lift the brush head before going over
obstacles (doorsteps).
•
Empty dirty water tank before folding
recovery tank over.
•
Use only cleaning agents suitable for
automatic machines (low-foaming)
and comply with the instructions for
use, disposal and with the warning
information specifi ed by the cleaning
agent’s manufacturer.
•
The machine is not designed for
collecting hazardous, infl ammable or
explosive dust or substances.
•
Usage of the machine in explosive
areas is prohibited.
•
Pull the ignition key to avoid
unauthorized use of the machine.
•
Before transporting the machine, lift
the squeegee and the scrub head
assemblies. Adapt operation of
machine to the local conditions.
•
The machine may be used only for
operation on plane areas with a
maximum inclination of 2 %.
1.4 Maintenance instructions
•
The daily and weekly maintenance
and repair task must be performed
by a qualifi ed operator. For any
maintenance and repair work
beyond this please contact your local
PowerBoss service center.
•
Observe the maintenance activities
•
and intervals set out in the instruction
manual.
•
Maintenance and repair work
should be carried out with use of the
appropriate tools.
