3
MAINTENANCE SCHEDULE
Item
Action needed
Page
500
2,500
5,000
10,000
15,000
Remarks
Intake air filter
Replace
4
●
▲
(Every 2,500 hours or less)
Part #91348550
Cooling fins
Clean
7
●
(Every 2,500 hours or less)
Blower fan
Clean
10
●
●
●
Fan duct
Clean
12
●
●
●
Bearings
Regrease
13
●
Service Center Only
Tip Seal set
Replace
22
▲
●:
Inspect
▲:
Replace
NOTES:
1. Inspect and perform maintenance periodically according to maintenance schedule.
2. The maintenance schedule relates to the normal operating conditions. If the circumstances and load condition are adverse, shorten the
cycle time and do maintenance accordingly.
3. *The tension of the V-belt should be adjusted during the initial stage and inspected every 2,500 hours afterwards. Proper belt tension for 3
HP unit is 7 lbs./0.16" deflection; for 5 HP units, 7 lbs./0.19" deflection.
4. Air end life is as below.
Regular pressure model: 20,000 hours, High pressure model: 15,000 hours
Operating Hours
(Every 5,000 hours for high pressure model)
(Every 5,000 hours for high pressure model)
Summary of Contents for SLAE03E
