- 18 -
Utilisation
Attention!
The pump is self priming. If the pump
q
does not start to suck up within 12
seconds, turn the drill
u
off immediately to avoid seizure. For this same rea-
son, do not allow the pump
q
to commence suction if the pressure hose on
the discharge side is closed.
Place the open end of the suction hose into the liquid that is to be pumped.
The suction hose may not be longer than 3 m. Ensure that the suction hose
does not pull in air.
If the pump
q
does not commence suction, fill the hose with some water
and then lift it so that the liquid runs before the pump.
Allow the drill
u
, now the pump
q
, to start-up – but not without supervision,
so that you can react quickly in the event of danger. Absolutely ensure
that the electric drill
u
is rotating to the right, as with normal drilling.
Should the rotation speed of the electric drill
u
be adjustable, you can
use this to regulate the discharge flow.
Turn the drill off immediately after the container is empty.
Cleaning and care
Clean the pump
q
with a dry or lightly moistened cloth only. To avoid damage
to the plastic surfaces, do not use solvents or abrasive cleaning agents.
The pump is maintenance free.
IB_75640_PBMP30A1_LB5.qxd 05.06.2012 12:11 Uhr Seite 18
Summary of Contents for PBMP 30 A1
Page 3: ...A B...
