POWERFIX PDM 250 A2
10 - English
Inserting/changing the battery
The multimeter is powered by a 9V battery. To insert or replace the battery, proceed as follows:
Switch off the multimeter and remove all test leads before opening the multimeter!
If the battery is exhausted, the
icon appears on the display [1]. The battery should be
replaced as soon as possible to ensure that the multimeter continues to work properly.
Remove the holster [2].
Remove the two screws on the back of the multimeter and remove the back panel.
Connect the 9V battery with the correct polarity (note + and –) to the battery clip and place
the 9V battery in the battery compartment.
Replace the back panel and screw it tight with the two screws.
Re-insert the multimeter in the holster [2].
Summary of Contents for PDM 250 A2
