Safety Instructions
• Connect the POWERGRIP Console directly to a stationary grounded power outlet. Do not connect with an
extension cord, power distribution unit, UPS, protection device or voltage stabilizer unless approved by the
manufacturer.
• Do not expose the unit to moisture. Use indoors only.
• In case of a device malfunction only use an authorized POWERGRIP service facility.
• A vibration damper is fitted inside. Do not shake, turn over the unit or put it on its side.
• To ensure proper filtration and protection, all powered devices in your AV system need to be connected to
a POWERGRIP console.
• Any kind of incoming antenna cables must be grounded with the connector supplied.
• Connect with correct Live/Neutral alignment only (13).
• This power console can withstand significant power surges, but it’s recommended to disconnect the
console's power plug from the mains during a thunderstorm.
• In case of a direct connection to the mains with a power line RCC (Residual Current Circuit) ‘Circuit Breaker’
an over Current Protection for 16A / 25A must be used.
What is in the box:
YG-3 Clean Power Console
Power cord IEC-C19-Schuko 2m
3RU Rack mounts
Antenna grounding cord
Blank plate cover, to be used in case of direct power cord connection
Useful knowledge:
Trigger input got optical isolation and support pass through mode. It will help you avoid ground loop
caused by trigger connection between processor and amplifier.
IFTTT service can help you to connect different IoT devices.
NOTE: Manufactures can change device specification without notification.