background image

 

6

it is plugged into a properly grounded 
power outlet, which supplies specified 
power and is protected by a 20 Amp 
circuit breaker. 
 

Physical Hazards 
 

Log splitting creates special physical 
hazards. Never operate this machine 
unless you are wearing proper safety 
gloves, hard-toed shoes, and approved 
eye protection. Be careful of splinters 
that will be produced during the log 
splitting process. To avoid puncture 
injury or jamming of the machine, never 
try to split logs that are too small to 
properly fit on the machine. Never 
attempt to split logs containing nails, 
wire, or other debris. Clean up as you 
work; accumulated split wood and chips 
can create a hazardous work 
environment. Never continue to work in 
a cluttered work area, which may cause 
you to slip or fall. Keep onlookers away 
from this machine, and never allow 
unauthorized persons to operate this 
machine.  
 

NOTICE: 
No list of warnings is all-inclusive. The 
operator must use commonsense and 
operate this machine in a safe manner. 
 
FEATURES OF THIS LOG 
SPLITTER 
 
1.  Portable – 

Small size, lightweight 

and built-in wheels make it easy to 
deliver this powerful machine to the 
work site. 
 

2.  Powerful

 – 7-ton power delivered by 

a sturdy hydraulic ram will make short 
work of your log splitting task. 
 

3.  Electric Powered

 – Convenient and 

reliable electric powered hydraulic 
system avoids the expense and hassle of 

maintaining a small gas engine. Just plug 
it in and start splitting. 
 

4. Hydraulic Ram

 – Powerful hydraulic 

ram splits logs in a safe, controlled 
manner, without axes or sledge hammers. 
 

5.  2-Hand Safety Control

 – Built-in 

safety design keeps hands away from the 
log and helps avoids coming in contact 
with splintering that may occur.  
 

6. Durable Steel Construction

 – 

Welded steel construction and enclosed 
hydraulic ram, make this a tough, 
durable machine you will use for years. 
 

KEY SPECIFICATIONS 
                                                   LS7T-52 

Electrical motor:  
110 volts – 120 volts/60 hertz 3340 rpm 
3 horsepower (2200 Watts) 
Max. force: 7 tons 
Log size capacity: 520 mm / 20.47” 
(length) 50 – 300 mm / 1.96” – 11.81”  
(diameter)  
Ram Travel: 300 mm / 11.81” 
Ram Diameter: 30mm / 1.18” 
Hydraulic Oil Capacity: 3.1 Liters 
Overall Dimensions: 1070 mm / 42.12” 
(length) x 300 mm / 11.81” (Width) x 
490 mm / 19.29”  (height) 
Net Weight: 49 kg / 107.8 lbs. 
 

Special safety regulations for the Log 
Splitter 
 
Warning:

 

This powerful log splitter presents some 
hazardous risks. Take precaution to 
protect yourself and those around you. 
Observe basic safety precautions to 
reduce risk of injury. Please carefully 
read this operation manual before 
starting work. 
1.  This machine must always be used by 
one operator only. 

Summary of Contents for LS7T-52

















Reviews: