PH4000Ri/E Owner’s Manual
18
6.3. Manual Start
1.
Move the remote selector switch to the “OFF” position.
2.
Insert the ignition key, and turn it to the ON position for three seconds. This will build up the appropriate pressure in
the fuel system, and allow the throttle valve to close.
3.
Pull the starter grip lightly until resistance is felt, then pull briskly out to start the generator.
•
Do not allow the starter grip to snap back. Return it slowly by hand.
•
Do not let the starter rope rub against the generator body or the rope will wear out prematurely.
6.4. Starting procedure using the remote function
1.
Move the remote selector switch on the control panel to the “ON” position.
2.
Push the start button on the remote twice and hold while the engine cranks 2-3 times without starting.
3.
Wait three seconds to allow the fuel pressure to build, and the throttle valve to close.
4.
Push the start button on the remote and hold until the engine has started or for a maximum of 10 seconds. Release
and repeat if necessary.
•
The maximum operating range is 75’ based on a clear line of site.
•
Always place the remote switch on the control panel in the “OFF” position when not in use for an
extended period of time, to prevent running down the battery. The remote switch will flash if the
remote switch is on while the generator is not running.
CAUTION
!
NOTE
!
Stop Button
