PH4000Ri/E Owner’s Manual
20
6.7.
Generator use
•
To prevent electrical shock from faulty appliances, the generator should be grounded. Connect a
length of heavy cable between the generator's grounding terminal and an external ground source.
•
Connections for standby power to a building's electrical system must be made by a qualified
electrician and must comply with all applicable laws and electrical codes. Improper connections can
allow electrical current from the generator to back feed into the utility lines. Such back feed may
electrocute utility company workers or others who contact the lines during a power outage. When
utility power is restored the generator may explode, burn, or cause fires in the building's electrical
system.
•
Do not connect the generator to an automatic transfer device. Severe damage to the inverter module
may result.
•
Do not attempt to connect generators in parallel.
•
Indoor use of a generator can kill quickly. Generators should be used outdoors only.
•
The total wattage of all appliances connected must be considered.
•
Do not exceed the current limit specified for any one receptacle.
•
Do not connect the generator to a household circuit. This could cause damage to the generator or to
electrical appliances in the house.
•
Do not modify or use the generator for purposes other than its intended use.
•
Do not connect an extension to the exhaust pipe.
•
When an extension cord is required, be sure to use a rubber sheathed flexible cord. Also be sure to
use the proper size and length cord.
–
16 Gauge Cords - a 16 gauge cord between 0 and 100 feet long will safely handle tool and appliance
loads up to 10 amps.
–
14 Gauge Cords - a 14 gauge cord between 0 and 50 feet long will safely handle tool and appliance
loads between 10 and 15 amps.
–
12 Gauge Cords - a 12 gauge cord between 50 and 100 feet will safely handle tool and appliance loads
between 10 and 15 amps.
• Keep the generator away from other electric cables or wires such as commercial power supply lines.
•
The DC receptacle (in the
Battery Charge
section of the control panel) can be used while the AC
power is in use. If you use both at the same time, be sure not to exceed the total power for AC and
DC.
• Most appliance motors require more than their rated wattage for start-up.
•
It is normal for the run time indicator to have 1-2 hours on the meter from the factory for testing and
quality assurance inspections.
WARNING
!
CAUTION
!
NOTE
!
