Problem
Log does not split
Log Pusher/Cam advances
jerkily or with strong
upward vibrations
Oil leak from the Cams or
from other external points
Probable cause
• Log is positioned incorrectly
• Log exceeds permitted
dimensions or the wood is too
hard for the capacity of the
Log Splitter.
• Wedge does not cut
• There is an oil leak
• Hydraulic pressure too low
• There is air in the circuit
• Leakage from the tank
• Seals worn
Corrective action
• Re-position the log.
• Make sure it is not at an angle.
• Stop the Log Splitter then turn
the log 90 degrees then try split-
ting the log again.
• Try to cut a small part or use
other means to reduce the size
of the log
• Sharpen the wedge, check for
burrs or nicks, file if necessary.
• Locate the leak using a piece
of card or wood. Contact your
dealer.
• Check oil level. Fill oil if
necessary. If problem persists,
contact your dealer.
• Make sure the bleed screw is
unscrewed.
• Contact your dealer
10
