Thank you for purchasing the XM-580 9-Ton Log Splitter. For your safety and your
personnel’s safety please read this operation manual carefully and strictly follow all the
instructions. This will ensure that you will enjoy a long and satisfactory use of this product.
SPECIAL WARNING WHEN USING THE LOG SPLITTER
Using this powerful Log Splitter may create special hazards. Take extra precautions when
using this Log Splitter to safeguard yourself and those around you. Please observe basic
safety precautions when operating and maintaining this Log Splitter to avoid injury.
GENERAL SAFETY RULES
The operation of this Log Splitter always carries the possibility of some risk of personal
injury to the user. To minimize the possibility of these risks when operating this Log Splitter
please follow these basic safety rules:
1. Read and fully understand this operation manual, including the proper use and scope of
application as well as potential hazards.
2. Before using this product, check for damaged parts. Inspect the protection device and
make sure there are no damaged parts to ensure the Log Splitter can operate normally and
perform its intended purpose. Check parts that are intended to move and test if they are
moving freely and do not appear to be broken or cracked. Note any other conditions that
may have a negative effect on the operation of the Log Splitter and have them checked by
an authorized professional if needed. You must make sure to have defective or damaged
parts replaced and have the Log Splitter repaired if it is not operating properly before actual
use and operation.
3. Before doing any inspection, calibration or other maintenance work on the Log Splitter
make sure that the Log Splitter is unplugged. Do this even when simply changing spare
parts such as wedge, chisel or cutting bar.
4. Keep the protective device in the state of readiness for work at all times.
5. Always check and make sure that the cord is intact and fully protected.
6. Do not open the switch box or the electrical motor cover of the Log Splitter. Contact an
authorized professional to do this if necessary.
7. Make sure the Log Splitter and cord are kept away from water and any moisture.
8. Handle the cord with proper care. Never yank or tear out the power cord. Keep the cord
away from high temperature, oil and sharp objects.
ELECTRICAL SAFETY
1. Before connecting the power cord to a power source, make sure the Log Splitter’s Electri-
cal Motor Switch is off.
2. Connect the power cord to a standard, properly grounded, power source that supplies
power that meets specifications stated on the Log Splitter nameplate and protected by a
16 Amp circuit breaker.
3. Do not operate the Log Splitter if there is an electrical hazard.
4. Do not operate the Log Splitter in wet conditions.
5. Do not operate the Log Splitter with an improper electrical cord.
6. Do not make electrical repairs by yourself.
7. If in doubt, always consult a qualified and authorized electrician.
2
