background image

4 - ENG

OPERA

OPERA

TING INSTRUCTIONS

TING INSTRUCTIONS

TYPICAL

TYPICAL

INST

INST

ALLA

ALLA

TION

TION

To begin using the tool:

1.

As a standard practice, drain water from 
the air compressor tank and air lines prior 
to use each day (reference your 
compressor operators manual for 
detailed instructions).

2.

Install a 1/4” NPT male connector (not 
included) into the air inlet port on the tool 
(see Figure 2). 

Note: Use Teflon® Tape 

on all threaded connections.

3.

Turn on the air compressor and allow it to 
build up pressure.

Always disconnect the 
tool from the air source
before changing the 
sanding pad or 
sandpaper. 

4. 

Attach an adhesive-paper backed sanding
disk to the sander pad by removing the 
adhesive cover and sticking it on the round sander pad. 

NOTE:  Remove used sandpaper from pad before storing the sander. Sandpaper can be difficult to remove

after a long period of time.

5.

Turn the offset knurled knob located on the spindle shaft until the knurled edge contacts the flat side of the 
drive spindle. This locks the spindle in place. Grasp the spindle area with one hand and screw the sander 
pad securely onto the spindle with the other hand. 

Do not operate sander with the spindle in locked mode. Doing so may result in injury
to you or others.

Damage sanding discs can fly apart and cause a serious injury. Replace the sanding 
disc when it is worn or damaged.

6.

Adjust the air compressor’s regulator or the supply line regulator to 90 PSI.

7.

Connect the tool to the air hose quick coupler. 

NOTE: It is recommended that a whip hose with a swivel 

(P012-0079SP - not included) be used to prevent twisting, kinking, and excessive wear to the air hose
(see figure 1 for recommended connections).

8.

Adjust the regulator control knob to the desired variable speed. 

9.

Squeeze trigger gently. Start the sander off the work. Set it down flat on the work surface. Move the sander 
slowly back and forth in wide overlapping areas. Let the sander do the work. Do not put additional pressure 
on the sander. This slows down the speed of the pad, reducing sanding efficiency and puts additional burden
on the air tool motor.

10.

When finishing sanding, lift sander off the work before releasing the trigger.

Key

Description

Key

Description

Key

Description

Key

Description

A

Air hose

D

In-line Oiler

G

Quick Coupler

J

Female Connector

B

In-line Filter

E

Air Hose

H

Male Connector

K

Spray Gun

C

Tee Fitting

F

Whip Hose

I

Air Tool

Figure 1

Figure 2

Summary of Contents for P024-0112SP

















Reviews: