Questions? Call Toll Free at 1-800-737-2112
Copyright © 2019 MAT Engine Technologies, LLC
EN - 7
Read and follow the assembly instructions . Do not discard
any parts or materials until the unit is assembled .
References to the right or left side of the edger are from
the viewpoint of the operator’s position behind the edger.
WARNING
Do not operate edger if it is damaged or not completely
and correctly assembled . Before doing any assembly or
maintenance to the unit, remove the wire from the spark
plug . Always wear ANSI compliant safety glasses with side
shields while assembling the edger .
Assembly
• Save all instructions
1 . Remove all parts and packaging components .
2 . Use a utility knife to cut all 4 vertical edges and lay the
side panels flat around the edger .
How to Remove Edger from Carton
A
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
NOTE:
Refer to Figure 2 when following steps below:
1 . Assemble the upper handle to the lower handle with the
(2) pipe bolts and the (2) plastic wing nuts . Firmly
hand tighten the wing nuts .
2 . Slide one end of the control rod into the hole of the
Depth Control Lever . Secure with hairpin .
3 . Slide the other end of the control rod through the hole of
the quill arm . Secure with second hairpin .
4 . Attach the recoil starter handle through the rope guide,
by twisting it into position .
5 . Remove the temporary insert from the engine ground
wire terminal .
6 . Connect the ground wires from the engine and handle .
Use cable tie to secure loose wire to handle .
WARNING
Ground wires MUST be connected for correct engine
operation . Failure to connect can result in serious injury .
How to Assemble the Handle
B
Upper
Handle
Lower
Handle
Hair Pin
Control Rod
Quill Support
Arm
Hair Pin
Pipe
Bolt
Figure 2
Depth Control
Lever
Recoil
Starter
Handle
Plastic
Wing Nut
Handle
Ground
Wire
Engine
Ground
Wire
Connection
Terminal
The following components will be found in the carton .
Quantities shown in ( ) .
1 . (1) Edger
2. (1) Edger Operator’s Manual
3. (1) Upper Handle
4 . (1) Control Rod
5 . (1) Container of Engine Oil
6 . (1) Parts bag containing the following:
(2) Hair Pins
(2) Plastic Wing Nuts (M8)
(2) M8x35mm Pipe Bolts
(1) Wire Tie
NOTE:
Depending on the model, the fasteners to attach the
wheels will either be loosely assembled to the unit or in a
separate plastic bag . See ASSEMBLY INSTRUCTIONS.
3 . Remove any remaining packaging .
4 . Roll the unit out from the carton, and place on a hard
level surface .