29
Special Cuts
The illustrations in this section show the profile, or
section, views made by the cutter(s). The most
efficient cutters are carbide tipped to ensure clea n
and long-term cutting. Small cutters may be solid
carbide, and some use inserts. Since there are
such a wide variety of choices, the operator is
limited only by his experience and imagination.
Stacked Cutters
A variety of interesting and timesaving cuts can be
made in a single setup by stacking the cutters.
When the operator stacks the cutters, extra care
should be taken to see that all parts are clean, free
of nicks and flaws, and perfectly balanced in the
stacked position.
Sash and Door Shaping
Shaping a door requires two operations.
Figure 53 shows the sash cut for the first
operation.
Figure 54 shows the stock flipped over and the
sash cutter used with a 1/4 inch groove cutter to
complete the cut.
Figure 55 shows the first shaping cut with the sas h
cutter for the matching door stile sash.
Figure 56 shows the same cut with the stock
flipped over.
Figure 57 shows the first shaping cut for a window
sash stile utilizing a sash cutter, collar, and a 1/2
inch groove cutter.
Figure 56
Figure 53
Figure 54
Figure 55
Figure 57
Summary of Contents for 2700
