Powermatic DDS-225, Operating Instructions And Parts Manual

5

18. Keep the floor around the machine clean and free of scrap material, saw dust, oil and other liquids to 

minimize the danger of tripping or slipping.  Be sure the conveyor table is free of all scrap, foreign 
material and tools before starting sanding operations.  

19.  Keep visitors a safe distance from the work area. Keep children away. 

20.  Make your workshop child proof with padlocks, master switches or by removing safety keys. 

21. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are 

careless acts that can result in serious injury. 

22. Maintain a balanced stance at all times so that you do not fall or lean against the blade or other 

moving parts. Do not overreach or use excessive force to perform any machine operation. 

23. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for 

which it was not designed. The right tool will do the job better and safer. 

24.  Use recommended accessories; improper accessories may be hazardous. 

25.  Maintain tools in top condition.  Keep tools sharp and clean for safe and best performance.  Dull tools 

increase noise levels and can cause kickbacks and glazed surfaces.  Check the condition and 
adjustment of the tools before making any cuts.   

26. Keep hands outside the machine. NEVER reach under the guards to try to clear stock that stops 

feeding.  Do not clear chips and sawdust with hands; use a brush.  Do not have any part of the hands 
under that part of the board that is over the table when starting a cut; the pressure roller will engage 
the board and force it down against the table causing a pinching action. 

27. Do not attempt to sand boards with loose knots or with nails or other foreign material, on its surface. 

Do not attempt to sand twisted, warped, bowed or “in wind” stock unless one edge has been jointed 
for guiding purposes prior to sawing. 

28. Do not attempt to sand long or wide boards unsupported where spring or weight could cause the 

board to shift position. 

29.  If the operator leaves the machine area for any reason, the sander should be turned "off" and come to 

a complete stop before his departure.  In addition, if the operation is complete, he should clean the 
sander and the work area.  NEVER clean the machine with power "on" and never use the hands to 
clear sawdust and debris; use a brush. 

30.  Turn off the machine before cleaning. Use a brush or compressed air to remove chips or debris — do 

not use your hands. 

31.  Do not stand on the machine. Serious injury could occur if the machine tips over. 

32.  Never leave the machine running unattended. Turn the power off and do not leave the machine until it 

comes to a complete stop. 

33.  Remove loose items and unnecessary work pieces from the area before starting the machine. 

Familiarize yourself with the following safety notices used in this manual: 

 This means that if precautions are not heeded, it may result in minor injury and/or 

possible machine damage. 

 This means that if precautions are not heeded, it may result in serious injury or possibly 

even death.