Checking Before Started :
Getting Started :
Stopping the Boiler :
Failure First Controls :
Checking and Starting the Boiler :
Following controls must be done before starting the boiler.If there are any problems or failure, boiler must not be started.
Water level of the boiler must be controlled. Water must be added to the boiler if the water level is low.
Please call rima technicians if there is a water leakage. Leakage must be prevented before starting the boiler. If there is a
leakage in the plumbing system,boiler must be started after repair.
Flue connections must be controlled. Boiler must not be started before repairing the connection if there is a problem.
Area must be properly air conditioned.
Gas valves must be checked as if they are on if gas fuel is used in the boiler.
Liquid fuel level of the tank must be controlled and fuel valve must be opened if liquid fuel is used in the boiler. Fuel - burner
connection must be controlled.If there are any problems , filters must be cleaned.
Working and the directions of the pumps must be controlled.
Electric system of the control panel must be controlled.
All water and gas valves of the boiler must be opened.
*** All other connections must be checked according to the system options.
Turn off the main fuse switch of the boiler room.
Turn the main electric switch of the boiler room on. Working lamp will be on.
Start the circulation pump.
Turn the ''on / off '' switch of the burner to the mode ''on'' (Check the burner instruction manual.) The indicator light will be on
.
Adjust the boiler temperature from the thermostat.If the burner is dual level, adjust the boiler temperature same the single
stage.Dual stage (TRZ) thermostat adjust the temperature changes own by own ( + 8 °C ).
If the burner does not start , follow the instructions written on the manual of the burner.If the burner does not start after
applying the written operations in the manual,call the technical service of the burner.
Turn the ''on / off'' switch of the burner to the '' off '' position
Turn the ''on / off'' switch of the control panel to the '' off '' position.
Turn of the circulation pump.
Turn of the fuel valves.
Burner must start.
If the boiler doesn't start or if the safety thermostate stop the boiler again please call Rima technical services.
If the burner safety light is on ; Please check the burner instruction manual or get in contact with the burner manufacturer or
distrubutor services.
When a problem or failure occurs in the boiler or the burner,please make the following first controls before calling technical
services. Don't do anything rahter than mentioned controls. After these controls call Rima technical services.
If boiler stops working and doesn't start again ; Safety thermostate may have stopped the boiler because of overheating at
boiler water.In this case wait for the boiler to cool down and please make the following controls.
Check if fuel is coming to the burner or not. If not , make fuel to come to the burner.
Check if pump is working or not. If not , this could be the reason of overheating.Please get in touch with pump manufacturer
or distributor.
Check if the valves are on or off.Open the valves if they are closed.
Please push the safety thermostate switch after the boiler is cold enough.
20
