Powermatic R100 Fitting Instruction Download

Page: 5 / 8

FRAME PREPARATION FOR
FRAME PLATE

DOOR PREPARATION FOR
BODY & DOOR PLATE

NB To ensure correct operation of

closer there must be a 3mm / 1/8” gap

between the two fixing plates when

the door is in the closed position.
These instructions are based on the
gap between door and frame being
3mm ± 1.0mm

•

Drill 4 x 28mm / 1 1/8”

Ø holes x 30mm /

1 5/16” deep to accept frame plate assembly

as indicated on template

•

Drill 2 x 28mm / 1 1/8” Ø holes x 5mm deep

to accept frame plate ends.

• Remove excess timber between drilled
holes to accommodate frame plate.

* IF USING INTUMESCENT
KIT R97-XX, REFER TO
INSTRUCTIONS WITH
KIT AS INSTALLATION
DEPTHS WILL INCREASE

•

Drill 4 x 26mm / 1 1/16”

Ø x 185mm /

7 5/16” deep holes to accept closer body as

indicated on template.

•

Drill 2 x 28mm / 1 1/8” Ø holes x 5mm to

accept door plate ends.

• Remove excess timber between drilled
holes to accept the closer body and door
plate.

Summary of Contents for R100

Page 4: ...o more than 35mm 1 3 8 from the pivot point of the hinge IMPORTANT To ensure the 35mm 1 3 8 distance is not exceeded the closer and fixing plate can both be offset in the door leaf and jamb closer to the hinge pivot point by up to a maximum of 6mm 1 4 as illustrated below Fig 2 ...

Page 6: ...rally for thicker doors expose both holes on each rod Insert the Allen keys C through both top and bottom link rod holes Both Allen keys must be correctly located Remove extractor bolt Secure door plate to door with six screws D IMPORTANT With composite doors and door linings it is essential to drill pilot holes Ø 3 32 2 5mm to suit fixing screws ...

Page 7: ... link rods across door plate and offer frame plate into frame void Secure with six screws D Open door slightly and remove Allen keys Installation is now complete Remove dust cap Use one of the Allen keys C to adjust closing speed Positive increases door speed Negative reduces door speed as indicated on door plate ...