9
Using Your Rout-R-Lift
Always turn router off and
disconnect router from power source before
making any height adjustment.
1. Depending on the size of the router bit you
are using it may be desirable to use an
insert ring to reduce the size of the opening.
To install the insert ring place the insert into
the opening of the main plate, then with the
insert wrench turn counterclockwise to
tighten (then remove the insert wrench).
See Fig. 15.
2. With the router bit installed, place the
adjustment handle into the access port in
the main plate (Fig. 16).
3. Bring the bit flush to the table top.
4. To raise your router, turn the adjustment
handle clockwise; to lower turn the
adjustment handle counterclockwise. Keep
in mind that one complete revolution of the
adjustment handle equals 0.050" or 1/20".
See Fig. 17.
5. Make the desired height adjustment. When
your adjustment is complete, remove the
adjustable handle.
6. A starting pin is provided to assist in certain
freehand operations when the fence is not
used. Thread the pin into the router plate
with a screwdriver (Fig. 18).
Figure 15
Figure 16
Figure 17
Figure 18
