第 1 页 共 16 页
Safety Instruction
JACK2000B Instruction Manual
1 Installation Instructions
1.1 Product specifications
Product Type:JACK200B; maximum motor speed: 5000 r / min; Supply Voltage: AC 220
±
44
V; Power frequency: 50Hz/60Hz; Maximum output power: 550W; maximum motor torque: 3Nm.
1.2 Pedal installation
First, With self-tapping screws fastening the pedals
①
under the proper position of the platen
②
.(direct drive servo motor
③
and control box
④
has been fixed on the sewing machine head
⑤
).
Then the two ends of the pedal connecting rod
⑥
are connected with the pedals
①
and the
bottom pedal
⑦
.
Fig.1-1 Direct drive machine controller installation diagram
·
Please read this manual carefully, also with related manual for the machinery before
use the controller.
·
For installing and operating the controller properly and safely, qualified personnel
are required.
·
Please try to stay away from arc welding equipment, in order to avoid
electromagnetic interference and malfunction of the controller.
·
Keep in room bellow 45° and above 0°
·
Do not humidity below 30% or above 95% or dew and mist of places.
·
Install the control box and other components, turn off the power and unplug the
power cord.
·
To prevent interference or leakage accidents, please do the ground work, the power
cord ground wire must be securely connected to an effective way to earth..
·
All parts for the repair, provided by the Company or approved before use.
·
performing any maintenance action, you must turn off the power and unplug the
power cord. There are dangerous high voltage control box, you must turn the power
off after one minute before opening the control box.
·
This manual marked with the symbol of the Department of Safety Precautions must
be aware of and strictly adhered to, so as not to cause unnecessary damage.
