第 12 页 共 16 页
Mode
Parameter
Default
Rang
Comment
5 3
1
1~100
Trimming counting proportion set up
5 4
1
1~9999
Trimming counting value set up
5 5
0
0~4
Trimming counting mode selection:
0: no counting
1: Counting up according to stitch number, after reaching set value
then restart.
2: Counting down according to stitch number, after reaching set
value then restart.
3: Counting up according to stitch number, after reaching set value,
then motor should stop automatically, recounting should be restart
by S4 [152.INI] =CRS or the button A on operation panel.
4: Counting down according to stitch number, after reaching set
value, motor should stop automatically, recounting should be restart
by S4 [152.INI] =CRS or the button A on operation panel.
61 0
0
／
1
／
2
Translating Parameter
0
：
no action
1
：
Download parameters( the panel will parameter from panel
to controller )
2
：
Upload parameters ( the panel will parameter from
controller to panel)
6 2
0
1, 2, XXXX
Restore storage parameter
(Only restore parameters to
operators, and vendors and
maintenance
)
Belt flat 1000/ Direct drive flat 2000
6 3
0
1, 2
Backup current parameter as user parameter for restore
(
restore
)
Operatio
n
Note:
Above such
“
6x "parameter to operate is not saved.
Fig.3-1 Pedal action parameter the position of the diagram
