121
B）Front is loaded with the illuminator multipurpose vehicle to be
supposed to have the low and far beam transducer and when the headlight
high beam becomes the headlight low beam, all headlight high beams
ought to be able also to extinguish. On the identical vehicle
Front illuminator does not allow left, right to be far, and the low-beam
lights. Alternately starts brightly;
c) When apposed setting the front illuminator far and low-beam lights,
the low-beam lights should be located on leans, in other situations
the low-beam lights should be located the flank
D）The front headlight low beam all does not allow dazzling.
e）The shines position of the front headlight low beam light beam, the
front illuminator shines when is away from 10m on the screen, the first
illuminator headlight low beam light beam light and shade closure line
corner or the center point highly should be 0.6H ~0.8H (H is front
illuminator datum center highly);
f）The front headlight high beam light beam and the headlight high beam
single light beam lamp should conform to the GB 7258-20048.4.7.3rd
corresponding requirement according to the position.
6.2.15 Light signal installment request
6.2 Requirements for torque of fastener
Tight spot
（N.m）Torsion value（N.m）
Column tight torque
35～45
Even fork axis nut
45～50
Front shock absorber upper nut
35～45
Front shock absorber lower nut
35～45
Rear shock absorber upper nut
45～55
