83
components (Reference the front bridge assembly, the figure of
the front box parts).
4.4.1.1 Preparation for disassembly and maintenance of front
bridge components.
1.。Check if the connection between wheel hub and conical
nuts is reliable and not loose.
2、If there is any distortion on the front wheel hub; the
wheel hub must be replaced immediately.
3. Whether the spare part does coordinate with the sheep horn,
whether the sheep horn bearing exists stagnation, check for
noise, if bearing is unreliable, and must disassemble the front
bridge
Assembly (refer to the front bridge assembly, the figure of the
front box parts), then instead the bearing to use. Check the
sheep horn whether have rupture, if so, instead it.
4. Whether the constant velocity joint does coordinate, to be
correct to the position; If is not correct or the coordination
is not
Good causes to the position hits the tooth and the
different sound,
Must dismantle it, installs and driving agine after the
position correct.
