www.powermaxfitness.net
19
All the treadmills’ driving belts are adjusted before leaving the
factory, but after using for a period, it may still occur slip, which
is mainly adjusted by users. Adjustment steps (see the picture):
•
Clockwise rotate adjustment screw with spanner.
•
Adjustment scope is subject to no slip when loading.
Notice:
Periodically clean the impurities in the belt groove and the belt wheel groove.
6. Treatment method of running belt slip or pause
First open the front motor cover, then open the treadmill, hold the hand grip with both hands,
step on the belt hard with your feet, watch it is the conveyor belt of the motor that pauses or the
running belt that pauses. If running belt pauses, adjust the running belt, while if conveyor belt of
the motor pauses, adjust the motor.
TROUBLESHOOTING GUIDE
Fault Code
Main reason
Solution
E01
The wire from computer to
bottom control board
didn’t connected well
1. Check the connection wire between
computer
and control board was well connected.
2. Make sure the IC on the control board was
well inserted. If not re-insert.
3. Abnormal power supply in control board.
Please change a new control board.
E02
Protect the exploding
1. Bad contact with motor open circuit. Please
change a new motor or check the connector.
2. Power tube was puncture. Please change a
new Power tube or control board.
E05
Over current Protection
1. Overloaded
。
2. Running board with heavy resistance. Need
to be oiled
3. Damage in Motor. Change a new motor.
E06
Control board self-checking
E08
EEPROM damage
Change the control board
