www.powermaxfitness.net
9
3. INSTALLATION
When installing, first simply fix all the screws, and then tighten up after the shelf has been installed.
Step1
Upright:
1.Uplift part of the upright and electronic watch dial,
use one M8*45 screw respectively on both sides of the
treadmill to pass through the below connection hole,
add the shims and tighten up the screws.
2. Tighten up the two uprights with two M8*20 Screws
Step 2
Electronic watch and hand grip Tighten up the hand
grips on both sides with M8*20 screw separately by
making them pass through handgrip hole and
connected with the uprights.
Step 3 (only for multifunction)
up and down U-shaped tube
First place the rubber protection sleeve at each side of
U-shaped tube, assembly 2 ends of U-shaped tube to
iron plate of left and right stand column with M8*40
screws, lock with nuts (special attention, the middle
screw hole of U-shaped tube point to the bevelled-up
direction-tube should not trap the L iron. Put on the
above it's approved. Down U-tube with foam, and
upper without it) see on the right picture
