www.powermaxfitness.net
11
E03: When the motor is running, the controller can
’
t test the speed signal.
Solution
Motor cable is not connected
Check connection
Under controller with abnormal signal
Change under controller to repair
E05: When the motor is running, current exceeds the rated current.
Solution
Treadmill motor load exceeds the rated
current
Recommend within the rated
current of the motor
Treadmill motor assembly structure
problems, causing the motor blocked
or resistance
Check the structure of treadmill
By limiting control system failure
Change under controller to repair
E07: Monitor can
’
t test the signal of security lock.
Solution
Safety Magnet off
Please set magnet safety lock
correctly
Electronic Safety lock system
malfunction
Change electronic to repair
Running belt adjustment method
1.
When running belt lean to the left, adjusting screw on the left 1-2 turns along the
clockwise. Then, test running; If still lean to the left, repeat the above steps until back to
the centre.
2.
When running belt lean to the right, adjusting screw on the right 1-2 turns along the
clockwise. Then, test running; If still lean to the right, repeat the above steps until back
to the centre.
3.
When the running belt too tight, it will cause stronger resistance. Please adjust both
sides screw 1-2 turns along the counter clockwise, loosen the belt until stopping
skidding or pausing; When the running belt too loose, please adjust both sides screws
1-2 turns along the clockwise.
