Important - Read before installing.
1
Must only be installed by a
LICENSED ELECTRICIAN to local
wiring regulations. Failure to
follow these instructions can
result in serious injury or death.
This is a semiconductor
switching device, the mains
power MUST BE SWITCHED OFF
before performing any wiring or
maintenance work.
AVOID THE RISK OF ELECTRIC SHOCK
Once the product has been fastened to the wall,
ensure the supplied screw caps are placed firmly
into the screw mounting holes.
Screw
mounting
holes
Factory Reset.
Remove the cover and press the RESET
button until the Powermesh indicator flashes blue.
Release the button and when the indicator turns
blue, it’s ready to pair.
2
Part Number:
PMLD, PMLDBK
Line Voltage Frequency:
50Hz Nominal
Load Brightness Control Range:
1% to > 95% (load dependent)
Rated Load:
Maximum Load 1A @ 250V / 250W
Minimum Load:
2W
Dimmable LED
Drivers & Lamps
Incandescent
Dimmable CFLs
Due to the variety of LED lamps / transformers /
CFLs, the maximum load and performance will
be specific to the product make and model.
Standard iron core &
toroidal transformers
Electronic
transformers
Specifications
Compatible load types
Surge protection is recommended
at the main switchboard. Products
that are damaged by power surges are not covered by warranty.
Powermesh products must only be connected with the
Active and Neutral from the same RCD.
3
• Press x 1 - on /off.
• Press & hold to dim.
• Press x 2 - full brightness
• Press x 3 - timed fade to off.
Set device Min & Max
dimming levels in
Zimi ‘Settings’ to avoid
flicker if necessary.
Light Dimming Button
with mini brightness
indicator.
Mounting screws
Reset Button
Using the Light Dimmer.
Powermesh
Status Indicator
See overleaf for the
meaning of each
colour status.
Snap on cover
MAC ID
Unique product
serial number.
Let’s get
connected.
Light Dimmer.
