10
CLEARING A JAM
Disassembly: (See Figure 4.)
1)
NOTE: Do not remove the two M5 screws (80).
2) Remove three M4 screws (78) with a 3mm allen wrench and lift off foot (71).
3) Slide the safety arm (75) to the side.
4) Lift the gate plate (72) off to clear the jam and inspect the drive blade (27) and its path.
Reassembly:
1) Make sure the drive blade (27) is centered and re-install the gate plate (72).
2) Slide the safety arm (75) back on top of the gate plate (72).
3) Install foot (71) on top of safety arm (75) and gate plate (72).
4) Install three M4 screws (78) and tighten.
(80) DO NOT REMOVE THESE TWO TOP BODY SCREWS
75
71
78
72
72
27
Figure 4.