1. An automatic airline oilier is recommended but oil
may be added manually before every operation or after
about 1 hour of continuous use.
2. Place two (2) drops of air-tool oil in the air plug as
shown (Figure 3). If you are using an automatic in-line
oiler, check and add oil if necessary.
3. Turn your compressor on and set the compressors
pressure regulator to the proper pressure for the size
and type of fastener being used. Normal operating
pressure should be adjusted between 70-110 psi
based on fastener and wood being used.
4. Connect the tool to the air supply.
7
MAINTENANCE
Figure 3.
WARNING!
1. Read and understand operating manual
before using.
2. Operator and all the by-standers must wear
ANSI approved safety glasses, ear and head
protections.
3. Never use oxygen or other fl ammable gases.
Only choose clean dry regulated compressed
air below 110 PSI pressure.
4. Remove fi nger from trigger while not
operating.
5. Never trip over the hose. Make sure all
connections are tight.
6. Disconnect the tool from air supply before
clearing jams, serviceing, adjusting or during
non-operation.
7. Don’t point tool at people or animals while
operating.
NAILER SAFETY LABELS
