REGULAR MAINTENANCE
1. Frequent, but not excessive, lubrication is required for best performance.
Oil added through the airline connection will lubricate internal parts. An
automatic airline oilier is recommended but oil may be added manually
before every operation or after about 8 hours of continuous use.
Only a few drops of oil at a time are necessary. Too much oil will collect
inside the tool and be blown out during the exhaust cycle. ONLY USE
PNEUMATIC TOOL OIL. Do not use detergent oil or additives, as these
lubricants will cause accelerated wear to the seals in the tool.
7
Figure 3
2. Use a small amount of oil on all moving surfaces and pivots.
3. Dirt and water in the air supply are major causes of pneumatic tool wear
. Use a fi lter/oiler for better
performance and longer life. The fi lter must have adequate fl ow capacity for the specifi c application.
4. Keep tools clean for better and safer performance. Use nonfl ammable cleaning solutions only if
necessary. CAUTION: Soaking the tool may damage O-rings and other
tool parts.
MAINTENANCE
WARNING!
1. Read and understand operating manual
before using.
2. Operator and all the by-standers must wear
ANSI approved safety glasses, ear and head
protections.
3. Never use oxygen or other fl ammable gases.
Only choose clean dry regulated compressed
air below 110 PSI pressure.
4. Remove fi nger from trigger while not
operating.
5. Never trip over the hose. Make sure all
connections are tight.
6. Disconnect the tool from air supply before
clearing jams, serviceing, adjusting or during
non-operation.
7. Don’t point tool at people or animals while
operating.
MODEL
2000F
1” - 1-1/4“ (25mm - 32mm) Length
USE 20 GAUGE L-POWERCLEATS
NAILER SAFETY LABELS
Operating Pressure
70 - 110 psi
Summary of Contents for Powernailer 2000F
Page 11: ...11 MODEL 2000F SCHEMATIC A...
