8
Power Source:
15 Amps 120 Volts 60 Hz Single Phase
Dimensions:
9" L x 7.5" H x 2.75" W
Weight:
3.25 lbs.
Fastener Capacity:
85 staples
Fastener Type:
20 Gauge 3/16" Crown
Fastener Lengths:
1/4" , 5/16" , 3/8" , 1/2", 9/16"
Recommended Minimum AWG Size for Extension Cords.
Cord length (Feet):
25 ft
50 ft
100 ft
150 ft
AWG size (gage):
14 gage
14 gage
12 gage
12 gage
Inspect your tools power cord regularly and ensure that all power and extension cords are in
good working condition. Any damages cords or connectors should be replaced.
This tool should be grounded while in use to protect the user from electric shock. Use only
3-wire extension cords that have 3-prong grounding type plugs and 3-pole receptacles that
accept the tool plug. Always replace or repair damaged cords.
Improper extension cord use may result in the risk of
fi
re and/or electric shock.
If an extension cord must be used, always be sure :
a. That the plug of the extension cord are the same number, size and shape as
the pins on the plug of the tool.
b. That the extension cord is properly wired and in good condition.
c. The wire size is large enough to carry the full AMP rating of the tool.
d. CAUTION: An undersized cord will cause a drop in tool voltage resulting in
loss of power and overheating. If in doubt, use the next heaviest gage.
The smaller the gage number, the heavier the cord required for safety.
Powernail PowerTacker™ TECHNICAL SPECIFICATIONS
Voltage warning : before connecting this tool to a power source (outlet, receptacle, etc.), be
sure that the power supply is of the same voltage as speci
fi
ed on tool.
Use of higher voltage than speci
fi
ed could result in serious injury to the user and damage
the tool. Use of a lesser voltage can also cause damage to tool. Never connect tool to a dc
power source. To guard against electric shock, prevent body contact with grounded surfaces
such as pipes, radiators, ranges, etc. While in use, do not touch metal parts of tool. Only hold
plastic handle.
Do not abuse power cord. Never carry tool by cord or yank it to disconnect from receptacle.
Keep cord from heat, oil and sharp edges. Disconnect tool when not in use, before servicing
and when changing accessories. When tools are used outdoors, use only extension cords
intended for outdoor use.
