POWDP7070
EN
Copyright © 2020 VARO
P a g e
|
10
www.varo.com
11 TROUBLE SHOOTING
Problem
Cause
Solution
The compressor does not
start.
1. No power supply.
2. outside temperature is too
low.
3. Motor is overheated.
1. Check the rechargeable
batteries.
2. Never operate with an
outside
temperature
of
below +5°C.
3. Allow the motor to cool
down. If necessary, remedy
the
cause
of
the
overheating.
The compressor starts but
there is no pressure.
1. The non-return valve
leaks.
2. The seals are damaged.
3. The drainage cock for
condensation water has a
leak.
1. Have a service center
replace the non-return valve.
2. Check the seals and have
any damaged seals replaced
by a service center.
3. Check the drainage cock
and replace if necessary.
The
compressor
starts,
pressure is shown on the
pressure gauge, but the
tools do not start.
1. The hose connections
have a leak.
2. A quick-lock coupling has
a leak.
3. Insufficient pressure set
on the pressure regulator.
1. Check the compressed air
hose and tools and replace if
necessary.
2. Check the quick-lock
coupling
and
replace
if
necessary.
3. Increase the set pressure
with the pressure regulator.
12 TECHNICAL DATA
Type
POWDP7070
Rated voltage
40V
Rotation speed
3000 min
-1
Rated Pressure
8 bar
Tank capacity
5 l
Air debit (capacity)
36 l/min
Weight
10 kg
13 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
87 dB(A)
Acoustic power level LwA
97 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
