POWX0090LI
EN
Copyright © 2013 VARO
P a g e
|
5
www.varo.com
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
Carefully wipe the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below:
Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
6.2
Chargers
Use the charger provided with the tool only to charge the battery
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
7 SAFETY WARNING FOR WORK-LIGHT
This is not a toy, children should not use it.
This is a DIY product, all electronic parts fixed already. Any intention of opening work-light
or changing work-light design is prohibitive. Please ask a professional electrician.
Do not attempt to replace or change the LED bulbs!
If the protective glass is cracked or broken, it must be replaced before the work light can
be used again.
8 OPERATION
8.1
Charging the battery pack (Fig. 1)
The battery pack (not included) has been shipped in a low charge condition to prevent
possible problems. You should charge them prior to use.
Note: Batteries will not reach full charge the first time they are charged.
Allow several cycles for the item to fully charge. The battery should only be
charged indoors.
After normal use, about 1 hour of charging time is required for the battery to be fully charged.
The battery pack will become slightly warm while charging, this is normal and does not
indicate a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room
temperature.
8.1.1
Charging indication
The charger has 2 LED lights (red and green).
Slide the battery pack in the charger as shown in fig. 1. Make sure there is proper contact
with the charger.
When charging the green is constantly lit and the red is flashing.
When fully charged both lights will be constantly lit.
