POWX07582
EN
Copyright © 2017 VARO
P a g e
|
11
www.varo.com
HAZARD!
Before using the machine, always check that the following items function properly.
Liftable saw blade guard.
Wear protective clothing
Stand in the correct position for operating the machine
At the front of the saw
In front of the saw
To the side of the sawing line
Crushing hazard! Whenever you tip the sawing head to the side, you must have a firm grip
on the handle of the saw head, keep your fingers away from the support arm and out of
the tilting range! Hold the saw head firmly.
If required by the type of work you are doing, you must use the following accessories:
Workpiece support for long workpieces, which would otherwise fall off the table at the end
of the sawing process.
Dust collector
Use an additional guide, if small pieces have to be sawn.
Always hold of the workpiece firmly on the table and do not block it.
Do not try to stop the turning of the saw blade, by pressing the workpiece against the edge
of the saw blade. A risk of injuries can occur, if the saw blade is blocked.
10.1.4
Normal cross-cut operations
Starting position:
Saw head completely raised.
Turntable in the 0° position; the locking screw of the turntable is tightened.
The motor head stands in a vertical position (90°), and the bevelling lock knob is tightened.
Sawing the workpiece:
Hold the workpiece against the mitre and width guide; if possible use a work clamp (25) for
fastening down the workpiece.
Activate the switch (20) and activate/push on the safety lock (6).
Lower the saw head carefully and completely downwards while gripping the handgrip. To
prevent that the speed of the motor slows down, you should only apply medium pressure
while sawing.
Saw the workpiece in one single movement.
Carefully let the saw head return to its topmost starting position.
The saw should be switched off by releasing the switch (20), if no further sawing has to be
done.
10.1.5
Mitre sawing
During mitre sawing, the workpiece is sawed at an angle in relation to the mitre and width
guide.
Starting position:
Saw head completely raised.
The motor head stands in a vertical position (90°), and the bevelling lock knob is tightened.
Sawing the workpiece:
Release the mitre locking knob (9).
Set the desired angle.
Tighten the mitre locking knob once more.
Hold the workpiece against the mitre and width guide. If necessary, use a work clamp for
fastening the workpiece.
Activate the switch (20) and activate/push on the safety lock (6).
