POWX0761
EN
Copyright © 2008 VARO
P a g e
|
12
www.varo.com
8.5
Switch action (Fig. 14)
8.5.1
Switch for the Mitre saw mode (A)
CAUTION:
Before plugging in the tool, always check to see that the switch lever actuates properly and
returns to the “OFF” position when released.
When not using the tool, remove the lock-off button and store it in a secure place. This
prevents unauthorized operation.
Do not pull the switch lever hard without pressing in the lock-off button. This can cause
switch breakage. To prevent the switch lever from being accidentally pulled, a lock-off
button is provided. To start the tool, push the lock lever to the left, press in the lock-off
button and then pull the switch lever. Release the switch lever to stop.
8.5.2
Switch for the table saw mode (B)
CAUTION:
Before operation, make sure that the tool is turned on and off.
To start the tool, press the ON ( I ) button. To stop it, press the OFF (O) button.
8.6
Adjusting the depth of cut (Fig. 15 - 21)
( In the table saw mode )
The depth of cut can be adjusted by turning the cutting depth adjusting knob. Turn the cutting
depth adjusting knob clockwise to raise the blade or counterclockwise to lower it.
WARNING: Use a shallow depth setting when cutting thin materials in order
to obtain a cleaner cut.
CAUTION:
The stopper pin cannot be turned with the tool head at fully lowered position. At this time,
turn the knob counterclockwise slightly and the stopper pin can be released. (Fig. 16)
9 ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and unplugged before carrying out any work on
the tool.
9.1
Socket wrench storage (Fig. 17)
The socket wrench is stored as shown in the figure. When using the socket wrench, pull it out
of the wrench holder. After using the socket wrench, return it to the wrench holder.
9.2
Table height two-way set up
The table height can be set up in two ways, high or low table.
WARNING: Before falling down the tool backwards, always set the tool in
the Mitre saw mode and lock the tool head in the lowest position.
9.2.1
High table set up (Fig. 18)
To set up the tool with high table, proceed as follows.
Fall down the tool carefully BACKWARDS without fail while holding it with both hands.
Fix the 4 legs using a bolt, wing nut and the U-shaped customized washer.
All manuals and user guides at all-guides.com
