POWX131
EN
Copyright © 2015 VARO
P a g e
|
6
www.varo.com
Keep mains lead clear from working range of the machine. Always lead the cable away
behind you.
The base plate must not be clamped down while the blade is extended. Lowering and
raising the blade must be a smooth operation,
7 ADJUSTMENTS
7.1
Adjusting the cutting depth
Move the motor base (14) as far as possible backwards.
Set the cutting depth by luring the cutting depth adjustment knob (6).
Move the motor base forwards and check if the pin will fall in the notch of the adjustment
knob.
7.2
Adjusting the cutting angle
The cutting angle can be set by unlocking the clamping knob (7} and put the angle stop (4)
in the required angle.
7.3
Adjusting the height
The correct height can be set by unlocking The clamping Knob (8) and turning The knob
for the height adjustment (9) to the desired height with aid of the scale (10)
The height must corresponds to half of the material Thickness of the work piece, the
groove lot the biscuit dowel must always be in The middle of the working piece
8 ASSEMBLAGE
ATTENTION! Disconnect the power plug before carrying out any
adjustments or maintenance..
8.1
Mounting saw blade
Loosen your screws and open the top of the base plate
Press the spindle lock and turn the spindle until it engages in the lock. Keep the spindle
lock pressed during this procedure.
Remove the flange nut from The spindle using the wrench.
Position the saw blade and the flange.
Place the flange nut from the spindle and tighten II with The wrench.
Take care that the flange nut will be placed with the correct aide on the spindle.
Release the spindle lock and check that the spindle is unlocked by rotating it.
Close the top of the base plate and fasten four screws.
Make sure that the top of the base plate is securely closed before operating
the machine.
8.2
Mounting dust bag
For dust extraction the dust bag can be used. Insert the dust bag into the vacuuming
Connection. Empty the dusts bag regularly so that the vacuuming performance remains intact.
9 OPERATION
9.1
Switching on and off.
Never use the spindle lock until the machine is working.
To switch the machine on slide the on/off switch forwards.
To switch the machine off, depress the on/off switch, the switch will automatically move in
the "off" position.
