POWX1706
EN
Copyright © 2021 VARO
P a g e
|
8
www.varo.com
6 OPERATION
NOTE! The appliance vibrates during operation. Therefore, always put it
down during operation.
Remove the required accessories from the accessory compartment (3).
6.1
Switching on and off
6.1.1
Switching the appliance on
Move the ON/OFF switch (1)
into the position “I” to switch the appliance on.
6.1.2
Switching the appliance off
Move the ON/OFF switch (1) into the position "O" to switch the appliance off.
Caution! This appliance is not designed for continuous operation. To
prevent the motor from overheating, the appliance may only be used as
follows: within a period of 10 minutes the appliance may only be operated
at the rated power input for 15% of the period, in other words, 1.5 minutes.
During the rest of the time period (cooling phase 8.5 minutes), the appliance
cools down again.
6.2
Compressed air hose with quick coupler (5)
6.2.1
Connecting:
Push the compressed air connector (9) into the quick coupler of the compressed air hose (5),
the sleeve automatically springs forwards.
6.2.2
Cutting:
Pull back the sleeve on the quick coupler of the compressed air hose (5) and remove the
compressed air connector (8).
Caution! When disconnecting the quick coupler of the compressed air hose
(5), hold the coupler firmly to prevent injuries caused by the hose flying off.
6.3
Inflation
6.3.1
Using the adapter
Schrader valve, tire valve
Area of use:
This application allows for a simple and accurate inflation of tires. The manometer (6) is used to
check the tire pressure. Thanks to the integrated release valve (7) it is possible to reduce the
tire pressure if it is too high.
