3
3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts rusty. And do not spray water
to the freezer, otherwise it will weaken the insulation and causes current leakage.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7. If the freezer is installed in unheated areas, garages etc., in cold weather condensation may form on the outer surfaces.
This is quite normal and is not a fault. Remove the condensation by wiping with a dry cloth.
STARTING
Final Check
Before you starting to use the freezer, please check that:
1. The interior is dry and air can circulate freely at the rear.
2. Clean the interior as recommended under "CLEANING AND CARE".
3. Insert the plug into the wall socket and switch on the electricity supply
，
then the Red light is on. Avoid accidental
disconnection by taping over the switch. Green light will glow and the compressor will start running.
4. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also
give rise to noise, whether the compressor is running or not which is quite normal.
5. If you going to store already frozen food open the freezer lid and check that the freezer has reached the correct
temperature. Then you can put in your already frozen food.
6. Do not load the appliance immediately after it is switched on. Wait until the correct storage temperature has been reached.
We recommend that you check the temperature with an accurate thermometer.
Important Notes:
• If there is a power failure do not open the lid. Frozen food should not be affected if the failure lasts for less than 20 hours. If
the failure is longer, then the food should be checked and eaten immediately or cooked and then refrozen.
• If you find that the lid of the chest freezer is difficult to open just after you have closed it, don’t worry. This is due to the
pressure difference which will equalize and allow the lid to be opened normally after a few minutes.
FREEZER OPERATION
Temperature adjustment
The temperature of the freezer is adjusted by means of the knob assembled on the thermostat. ”1
、
2
、
3
、
4
、
5” do not represent
a specific temperature. The smaller the No. the higher the temperature, whereas. So, position “5” is being the lowest
temperature.
Figures mean:
“
OFF
”
：
Forced Shutdown Point
1—5
：
Frozen Interval
（
from -12
℃
to -30
℃
）
The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance,
ambient temperature, and frequency of lid opening, extent of filling with food of the freezer. The position of the thermostat
knob will change according to these factors. Normally, for an ambient temperature of approx. 25
℃
, the thermostat should be
adjusted to the mild position.
We recommended that you check the temperature with a thermometer to ensure that the Freezer is kept to the desired
temperature. Remember you must take your reading very quickly since the thermometer temperature will rise very rapidly
after you remove it from the freezer.
Please remember each time the lid is opened cold air escapes and the internal temperature rises. Therefore never leave the
lid open and ensure it is closed: immediately after Food is put in or removed.
Due to individual factors of the refrigerator, the actual temperature in the box may have a certain error from
the set temperature, which is a normal phenomenon and does not affect the normal use of the product.
Indicator lights
The indicator light set is placed on the front side of the freezer for easy visibility.
Indicator lights mean the following:
