www.powershield.com.au
6
2. Installation And Setup
NOTE:
Before installation, please inspect the unit. Be sure that nothing inside the package is
damaged. Please keep the original package in a safe place for future use.
2-1. Rear Panel View
PSCM1100
PSCM1500/PSCM2000
1.
Programmable outlets: connect to non-critical loads.
2.
Output receptacles: connect to mission-critical loads.
3.
AC input
4.
Input circuit breaker
5.
Emergency power off function connector (EPO)
6.
USB communication port
7.
RS-232 communication port
8.
SNMP intelligent slot
2-2. Setup the UPS
Before installing the UPS, please read below to select proper location to install UPS.
1.
UPS should be placed on the flat and clean surface. Place it in an area away from vibration,
dust, humidity, high temperature, flammable liquids, gases, corrosive and conductive
contaminants. Install the UPS indoors in a clean environment, where it is away from
window and door. Maintain minimum clearance of 100mm in the bottom of the UPS to avoid
dust and high temperature.
